Guidance for the use of the waterpipe

The waterpipe and their impact

The connections between the individual parts of the "Nargileh" must be closed, that on the one hand no air will absorb wrongly, and on the other hand no smoke can exit in a wrong direction. The waterpipe functions on the principle of the negative pressure. The water tank is a filter for the connection of tar and nicotine. The length of the pipe (thus the overall height) depends on:
1. Place of the use (desert, etc..)
2. Daytime temperatures
The pipe leads  into the water tank and and into the water. At the upper end is a connection to the head, that the tobacco takes up. The hose is attached in the top of the water tank. If one sucks thus at the hose, thus a negative pressure develops in the water tank. Thus the water level and new smoke lift themselves can the water tank
occur, the smoke is led and cleaned by this procedure by the water, in addition it is naturally necessary, that the smoke is so far as possible cooled down, which by the long pipe above the water tank is caused.

 

The correct cleaning

A waterpipe consists to the largest part of brass, from glass, and from leather and/or. from plastics. 
Thus each part needs its special care.

1. Glass
The glass should be cleaned best with warm water and table-ware
detergent.
The warm water therefore, so that no arrears of the table-ware detergent remain in the glass, which leads when smoking to a bad taste.
With inaccessible glasses, or with waterpipes with a water tank from brass one knows also a
tablet with tooth cleaner solved in water, over night in the water tank to be located let rinse out and in the
morning well.
In order to avoid in principle the creation of nicotine and tar at the
glass, there is a proven method. Give during smoking a half lemon to smaller pieces cut to the water. This results in first of all apart from the selected flavour (apple, Peppermint etc..) also an aromatic lemon taste, and secondly the citric acid does not permit the setting on the glass.
Particularly is to be paid attention to it, that the water is in the glass always fresh and clean, since it comes otherwise to unwanted smell and taste formation.

2. Brass
With untreated brass it is advisable (you rather smoke in such a way than deseam), to treat the whistle with colorless spray lacquer. Afterwards it is enough, to wipe off the whistle outside with a dry cloth. With chromium-plated whistles it is sufficient to wipe generally these off damp and dry then.
The interior pipe should be through-deseamed after each smoke
procedure with the whistle brush, also this is to be avoided essential around bad smell. However nevertheless bad smell should have set, thus it helps, the whistle some days divides in the free one, Z.B. on the balcony, to keep.

3. The hose
in former times from leather manufactured, consists nowadays of plastics or paper (depending upon quality and price).
Since the connecting piece from wood is manufactured, one should mark out and hang the hose up after use, so that the wood can drain again. If the hose is cleaned, which each week should be once, then we recommend, to flush this with clear warm water, afterwards to hang up and, so that the water from above can flow off downward and withdraw unhindered. With cheap paper hoses one should do without the cleaning, since the water dissolves the paper adhesive and makes the hose thereby useless.
You should be in the lucky situation, a genuine leather hose to have arisen, thus you use these for the decoration and you long will enjoy.

4. The head of the pipe
should be emptied and cleaned after smoking immediately, since it comes otherwise to incrustations, which leads in the long run to the close of  the holes inside the head, and the head makes useless.

5. The pipe 
Should be through deseamed after each smoke procedure by means of a brush planned for it. The pipe should be provided with a valve to the smoke blowing, so the top is to be unscrewed, the ball to remove and with water through zuspuelen. Subsequently, the valve should be dried with a paper handkerchief or a
material cloth.

Smoke preparation

1. First you should fill the water tank, so, that the pipe, if you it into the water tank put approx.. 2 cm in the water immerses. 

2. Invert the plastic ring over the lower seat at the pipe. The plastic ring should have been lost broken or, like that this no reason is for despairing. For centuries water pipe smokers use linen strips for sealing. Plastic rings are an achievement of the last 10-15 years. Cut thus linen in strip which are approximately as broad as the seat
of the pipe in the glass. Then you push taped seat into the bottle. This should be possible only under gentle pressure, in order to ensure a good seal.

3. Put the plate from above on the pipe, so that it comes flat to the edition. 

4. The hose should not be completely close in the photograph pipe, thus you proceed as with a densities of the pipe into the water
bottle. If this happened, thus you try to suck in at the hose. If the water begins to bubble in the bottle apparently, this is an indication of tightness. It should you substantial effort of force cost suck in, so can the following causes have:
1. The pipe rises up too far into the water
2. With a densities with material a piece of the same pushed itself
before a suction hole. Correct they the seat of the material and try you it again.
3. The wood in the hose beginning swelled, there helps only the hose to hang up and some days dry to leave. If you have, use a spare hose. 

4. Filling the head with tobacco. Here it differs, which kind of tobacco you use.